Notifications
Clear all
PrusaSlicer 2.5.0 & MINI+, printer ends by diving into bed. Why?
Prusa MINI+ on PrusaSlicr 2.5.0 dives diagonally into the bed and puts the nozzle exactly in contact with it, at the end of prints now. Why?
(This is undesirable as it could damage the bed; previous behaviour was that it would end by going back to the corner and moving Z upward a bit, blindly.)
Best Answer by FoxRun3D:
Well known issue. Solved by upgrading your firmware.
Posted : 08/11/2022 10:11 pm
RE: PrusaSlicer 2.5.0 & MINI+, printer ends by diving into bed. Why?
Well known issue. Solved by upgrading your firmware.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Posted : 09/11/2022 1:47 am
Neophyl liked
Topic starter
answered:
RE: PrusaSlicer 2.5.0 & MINI+, printer ends by diving into bed. Why?
Thanks for that - I found this article which showed how easy this is to do:
https://help.prusa3d.com/article/firmware-updating-mini-mini_124784
This solved the problem. Thanks again.
Posted : 10/11/2022 1:20 am