PrusaSlicer 2.4.2 error finish printed
 
Notifications
Clear all

PrusaSlicer 2.4.2 error finish printed  

  RSS
Marc
 Marc
(@marc-5)
New Member
PrusaSlicer 2.4.2 error finish printed

Since I did install the last version, PrusaSlicer 2.4.2, the 3d printer head finish print with position Z0. This error can cause a shock with printed piece.

Napsal : 29/07/2022 10:30 am
FoxRun3D
(@foxrun3d)
Famed Member
RE: PrusaSlicer 2.4.2 error finish printed

I suspect that particular printer is not on the latest firmware version. This has been reported many times before and can be fixed by updating both slicer and firmware to the latest version. 

Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...

Napsal : 29/07/2022 10:59 am
Marc se líbí
Share: