Prusa Slicer 2.7.4 dropdown menus order
 
Notifications
Clear all

Do you think it would be good to change the order of the dropdown menus? Poll is created on Jun 15, 2024

  
  

Prusa Slicer 2.7.4 dropdown menus order  

  RSS
MisterCreators Custom MOCs
(@mistercreators-custom-mocs)
Member
Prusa Slicer 2.7.4 dropdown menus order

Hello everyone,

I've lately switched to the Prusa Slicer (V2.7.4) after buying my first Prusa printer. Now, after I've got my first few prints done and added my other printers as well, I wondered if it wouldn't be better to change the layout of the dropdowns on the right site.

For now, you choose:
   1. your print settings (which depend on the printer)
   2. the material
   3. the printer

But in my opinion, it would be way more logical to change the order of these dropdowns to choose:
   1. the printer
   2. the print settings (because they depend on the used printer)
   3. the material

Other than that, the Prusa slicer is an excellent slicer.

Best regards 
Adrian

Posted : 15/06/2024 12:11 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Prusa Slicer 2.7.4 dropdown menus order

Hi Adrian, 

Suggestions like this are best made on the Prusa Slicer GIT HUB Page, where the Developers hang out!

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 15/06/2024 1:42 pm
Share: