Notifications
Clear all
Problem with Prusa Slicer 2.5 and 2.6
Hi, I have an Anet A8 plus a self build Dbot CoreXY printers and after trying Prusa Slicer 2.5 and 2.6 I have real issue with settings so was wondering if anyone has settings that I could use on these printers ...
I have used Creality Ender 3 for Anet and Creality Ender 5 for Dbot but the results I get are aweful ...
The Dbot prints resulted in, instead of moving filament to nozzle it would retract but then not move filament back into nozzle so ended up at the feeding gear on the stepper motor after a short while ...
I have always used S3D and results are fine on Anet but not as good on Dbot ...
Regards John
This topic was modified 1 year ago by John40131
Posted : 30/08/2023 1:16 pm