Printer stop printing - PrusaSlicer https://forum.prusa3d.com/forum/prusaslicer/printer-stop-printing/ Prusa3D Forum Discussion Board en-US Sat, 11 Apr 2026 01:57:52 +0000 wpForo 60 https://forum.prusa3d.com/forum/prusaslicer/printer-stop-printing/#post-729742 Fri, 13 Dec 2024 23:36:20 +0000 2.9 is an alpha, a test version intended for experienced users to experiment with.  It is not intended for regular use.

The correct procedure is to make a full description of the problem includng the settings you used and report it on Prusa's github for the developers to examine and remedy - then revert to the regular release until, perhaps, the devs will contact you and ask you to test an update.

Cheerio,

]]> PrusaSlicer Diem https://forum.prusa3d.com/forum/prusaslicer/printer-stop-printing/#post-729742 Printer stop printing https://forum.prusa3d.com/forum/prusaslicer/printer-stop-printing/#post-729682 Fri, 13 Dec 2024 09:24:18 +0000 Greetings

I have a problem with Prusa slicer 2.9.0 alpha1. I use the Anycubic Viper printer and it happens that the printer stops printing either at the beginning or in the middle and just stops. I tried to format the sd card and use another new one but it happens every 3 or 4 prints. Should I go back to the previous version of the slicer or is it not compatible with this printer?

Thank you

]]> PrusaSlicer LuLac https://forum.prusa3d.com/forum/prusaslicer/printer-stop-printing/#post-729682