Notifications
Clear all
Printer crashes since installing Slicer Version 2.9
Since I upgraded to Prusa Slicer 2.9 I experienced, that my MK4s/MMU3 after finished priming the filaments stops doing anything. The heating of nozzle and printing bed keeps ON. After trying to stop printing it crashes without any further movement or retracting.
Yesterday after a crash I tried to generate the slicer project again with success. But today with a different part the same behavior comes again. I started with a complete new Slicer Project I use PETG for part and supports and PLA as support interface. I observed that every time the print crashes PETG will be initialized with bed temperature of PLA even if PETG is shown as loaded filament.
Is this a bug of the new Slicer Version or what could cause this strange failure?
Posted : 25/12/2024 2:46 pm