Perimeter not sticking on curved surface
Good morning
Someone has an idea why an outer perimeter won't stick? Especially on a curved surface? Looks like the extruded filament is too short and starts sticking as soon the curved surface ends. But it also happens sometimes on flat surfaces...no clicking noise of the Micro Swiss direct drive extruder....
I slowed down the speed an also increased temperature....but no success.
Interestingly the infill is fine.
with Micro Swiss Direct Drive, BTT SKR v1.3 and TMC2208<br>Ender-3 with Micro Swiss Direct Drive, E3 mini with TMC2208<br>Qidi i-Mate S
RE: Perimeter not sticking on curved surface
Not sticking on the first layer is often due to improper Z calibration (bed leveling), contamination on the build plate, or a need to use an adhesion booster.
RE: Perimeter not sticking on curved surface
It's not the first layer......first layer is perfect 😉
with Micro Swiss Direct Drive, BTT SKR v1.3 and TMC2208<br>Ender-3 with Micro Swiss Direct Drive, E3 mini with TMC2208<br>Qidi i-Mate S