one support randomly missing from 1st 2.9 sliced print on mk 3.9
 
Notifications
Clear all

one support randomly missing from 1st 2.9 sliced print on mk 3.9  

  RSS
jphakola
(@jphakola)
Member
one support randomly missing from 1st 2.9 sliced print on mk 3.9

Just installed the new 2.9.0 slicer to OS X 14.5 mac mini and decided to print few battery crates with my Mk 3.9  from an ancient reel of PLA and after the print found something odd:

In the slicer normal organic supports have been created form all 4 sides of the crates

But in the print 3 out of 4 sides are ok but the centermost supports are missing from both prints.  Not failed, not collapsed, no messed up pile of plastic anywhere but one was completely missing without even brim in the plate and only few layers of the other were created.

Interesting failuremode 🙂

Posted : 26/12/2024 5:09 pm
Share: