Notifications
Clear all
Object outside print volume...when its not
I know there is another post with this same exact subject line, but this is different. I have a bucket created with fusion360 that is 190 mm in diameter. Its exterior is an exact cylinder. When I export the bucket to pslicer with prusa i3 mks3+ printer set I get the error "Object outside print volume". You can see from the attached screenshot that it fits.
What can I do about this?
Best Answer by mchahn:
It was too tall. (Is there a way to delete posts?)
Posted : 13/10/2021 10:40 pm
Topic starter
answered:
duh, found my problem
It was too tall. (Is there a way to delete posts?)
Posted : 13/10/2021 10:48 pm
Too tall?
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Posted : 13/10/2021 10:49 pm