Notifications
Clear all

Minimal Purge Needed!!  

  RSS
work n hard not hardly workin
(@work-n-hard-not-hardly-workin)
Active Member
Minimal Purge Needed!!

Hi I am at a loss for what to do. I have a MMU3 and MK4 set up, mainly printing PLA and then PETG as the supports. My problem is that no matter what I do it still purges an ungodly amount of filament for the PETG despite all values being zero (see attached pictures). I only want it to purge and prime PLA, I don't want this for the PETG to purposefully make the supports as weak as possible. All values are zero!!! so what is keeping it from being practically zero?? In the last picture in the Wipe Tower section of the Prusa Knowledge base there is a ridiculously small wipe tower(see the last picture), I want that! How does zero not achieve that??? My purge amount is 60 for the PLA as it is black to red (I changed it in the picture for a better visual)

SO WASTEFUL!!😡from the knowle

Posted : 03/06/2025 8:08 pm
Share: