Notifications
Clear all
How to force all perimeters before infill in PrusaSlicer post update 2.5.2
The behavior of infill and perimeter print order was changed after PS update 2.5.2. Previous to 2.5.2 perimeters, all of them on the entire part would print first, then the infill would print. Since that update, infill not surrounded by perimeters prints first, then the perimeters print, then the infill within those perimeters print. All features within the same part. attached is gcode from 2.5.2 and 2.8.0 so you can compare: 3mf and gcode.
I prefer the previous behavior and am hoping there is a way I can get the latest updates to behave in this way so I can utilize the newest features.
Posted : 29/07/2024 6:23 pm