Custom Profile for Lithophanes
 
Notifications
Clear all

Custom Profile for Lithophanes  

  RSS
JCCBSL
(@jccbsl)
Eminent Member
Custom Profile for Lithophanes

I'm looking for a custom profile to use when printing lithophanes on my MK3s. 

 

Best Answer by Neophyl:

Found this one https://github.com/eoprede/prusa_profiles/blob/master/MK3/Slic3r/Pretty%20Litho%20PLA.ini

Not mine so dont know how effective it is and looks like it was generated with the 1.41 Prusa Slicer version.

Posted : 11/09/2020 1:42 pm
Rob
 Rob
(@rob-4)
Active Member
RE: Custom Profile for Lithophanes

for me just add a large brim 10mm or so and mine print just fine when printing them vertically.

Posted : 18/09/2020 4:33 am
Neophyl
(@neophyl)
Illustrious Member
RE: Custom Profile for Lithophanes

Found this one https://github.com/eoprede/prusa_profiles/blob/master/MK3/Slic3r/Pretty%20Litho%20PLA.ini

Not mine so dont know how effective it is and looks like it was generated with the 1.41 Prusa Slicer version.

Posted : 18/09/2020 6:39 am
Rob
 Rob
(@rob-4)
Active Member
RE: Custom Profile for Lithophanes

Out of curiosity what are you looking for, like what specifically is different from printing a lithopane properly sliced than anything else? Sorry for my ignorance I have done a few just using my regular profiles.

Posted : 18/09/2020 7:15 am
JCCBSL
(@jccbsl)
Eminent Member
Topic starter answered:
RE: Custom Profile for Lithophanes

Thanks for the suggestions.

I've been striving for a higher quality lithophane.  It appears that everybody seems to have their own personal preferences on settings (layer height, etc.) and I was curious to see if there were some variables that were consistent among users.  What I have discovered is that the filament used seems to have more affect on the final print than anything else. 

Posted : 18/09/2020 12:56 pm
Share: