Posted by: @gb160

Bit of a documentation dump here, some of it relates to CoreONE

https://github.com/BondtechAB/INDX/

Nice actual if you look at prusa forms they add new topics in recently.  I think we are getting closer to units being sent out. =)

 General discussion, announcements and releases (1 viewing) 

Assembly and first prints troubleshooting 

Hardware, firmware and software help (1 viewing) 

How do I print this? (Printing help)  User mods

https://github.com/BondtechAB/INDX/

With regards to issues with MMU3 that others have mentioned, the only problem I have faced so far, is the odd loading issue, where no matter how hard I try to straighten out the last 3 inches of filament, it won't feed into the unit, oh and it randomly feeding an inch or so of filament, that isn't being used and only finding out when it changes tools and it jams 😅

Lately though, it has been behaving.......but of course I have now said it and tempted the filament gods to meddle in my affairs 😅

So back on topic, the INDX on the Core One. It's my dad's Fiat. No filament feeders, no RFID readers (yet) and a patched up PrusaSlicer and firmware with macros to make it work. If there is a problem with it (and expect there will be), the place I will need to go for help is unfortunately Discord or (fortunately) here.

Agreed

Posted by: @3d0zer

Can you please tell what not went well with multicolor on the Bambu's? 

 

With a traditional AMS setup there was simply too much purge waste and it took too long to print. In most cases the purge waste weighed more than the model. And a 30 hr print on the H2D would theoretically (I simulated in the slicer) take only 3-4 hrs on the INDX and with very little purge waste. The H2C with Vortek system was much better than the H2D but it was still too slow. There wasn't the same purge waste but it still took time to retract the filament back into the AMS and swap out the nozzle on each color change. 

Posted by: @3d0zer

Can you please tell what not went well with multicolor on the Bambu's? 

 

I am sorry I derailed this train.

Don't worry. Not much else to talk about, really, until the units ship. Which I doubt will be the day they promised. 

I'm looking forward to experimenting with multi-color on the INDX. I tried on the H2D and briefly on the H2C (long and funny story) and it just fell flat. Bondtech/Prusa should hit a home-run with the INDX system over their rivals.