Notifications
Clear all
VFA still there after all "fixes"
Even after tensioning belts (i overtensioned both belts), using new slicer and new firmware (6.4), i still get extremely visible and VFA's i can feel. On top of these issues, the quality seems to change suddenly. I am using speed profile too to further improve visibility of VFA's but it does not seem to work. I get occasional layer shifts on prints too (possibly from the over tension?) but small enough where the print can finish. Can someone help me figure out next steps to fix the quality and VFA's?
Posted : 29/09/2025 7:27 pm
RE:
Same here. On the right it's something print with my A1 mini, and on the left with the Core One. Overall quality is not bad, but not as good as the A1 mini. I can't wait to see the next upgrades.
This post was modified 6 hours ago by Kyosuke_14
Posted : 30/09/2025 8:21 pm