Notifications
Clear all

Chamber Auto-Dimming  

  RSS
David R. Campbell
(@david-r-campbell)
Eminent Member
Chamber Auto-Dimming

Does anyone okow when the chamber lights are supposed to Auto-dim?  Mine are on 100% all the time, even though Chamber Auto-Dimming is turned on in the User Interface settings. 

Give the Buddy3D camera's struggling in low-light conditions, I would think the chamber lights would be on during the print process, and only turn off after the machine has been in a ready state for some period of time.

Posted : 26/06/2025 6:35 pm
Mempf
(@mempf)
Member
RE: Chamber Auto-Dimming

They dim after only a few minutes at most. This likely implies your door sensor is not detecting the door is closed. The light is kept at full brightness when the door is open.

Posted : 28/06/2025 8:08 pm
David R. Campbell
(@david-r-campbell)
Eminent Member
Topic starter answered:
RE: Chamber Auto-Dimming

I'm looking for the opposite behavior.  I'd rather the light be on 100% while printing and the camera is on and only auto-dim after no activity for x minutes.

Posted by: @mempf

They dim after only a few minutes at most. This likely implies your door sensor is not detecting the door is closed. The light is kept at full brightness when the door is open.

 

Posted : 29/06/2025 11:21 pm
1 people liked
Mempf
(@mempf)
Member
RE: Chamber Auto-Dimming

Oh yeah. The current auto-dimming option in the user interface settings is an all or nothing thing today. It either auto dims when the door is closed or it never auto dims. I also would like an auto dim only when idle option, that sounds great.

Posted : 29/06/2025 11:51 pm
Share: