Notifications
Clear all
Prusa core one + front right side profile not aligning
Hello im at the chapter 7 bodywork&eletronics step 3 and im having trouble aligning the top srews with the bottom ones .I tried to push down the rods all the way in but that made it just slightly better.Also i tried to the front left profile and it went without any issues.I am sure that im using the correct pannel.
Posted : 09/01/2026 6:46 pm
RE: Prusa core one + front right side profile not aligning
I recently build a Core One, and that step was a bit difficult in getting everything lined up. I believe I ended up loosing some of the bottom frame screws and then tightened everything back up afterwards.
Posted : 10/01/2026 1:45 am