Printing plates included in the kit - General discussion, announcements and releases

RE: Printing plates included in the kit

epas — Tue, 13 Jan 2026 15:56:06 +0000

Thanks for replying. I was aware of this, but it happens that I overlooked the contact link on the web site. I just gave it a more in-depth read and found it.

Sorry for the disturbance.

RE: Printing plates included in the kit

k1mu — Tue, 13 Jan 2026 15:20:58 +0000

Remember that there's no significant Prusa presence here on the forums, and since only Prusa can answer that question you're probably going to have to contact them to see if you can make the swap.

Printing plates included in the kit

epas — Tue, 13 Jan 2026 14:54:00 +0000

Hi,

I'm about to order the kit version of the Core One + (2 MK3S already assembled 5+ years ago and running still fine) and I'm wandering if there could be any option for swapping the plate included by default with a satin one.

It's not that much the additional 50 Euros of the option (not a big deal compared to the total cost of the kit) than the fact that there are few chances I'll ever use the PEI one. It would thus be a perfect waste of equipment. It happens that I've used the MK3S satin plates exclusively since I've bought them and can't see any reason to use PEI ones again.

Any thought ?