Notifications
Clear all

X Axis Will Not Pass on Calibration  

  RSS
JoelTrucordia
(@joeltrucordia)
Member
X Axis Will Not Pass on Calibration

I just received my Core One Kit. I had a heck of a time getting the belts tight because the app stopped listening all the time, and once I had them tuned the alignment was off. But I have the belts both sitting at 83hz zero play on the front gantry and y axis passed. When I select the X axis it will move to the opposite site and then the screen goes back to the calibration screen and shows a red X. I have no idea what it could be at this point. Please Help!IMG_0015

Posted : 16/07/2025 10:52 pm
JoelTrucordia
(@joeltrucordia)
Member
Topic starter answered:
RE: X Axis Will Not Pass on Calibration

I noticed after a complete reset that the X axis will only pass if I move the gantry and extruder to the back left corner 

Posted : 18/07/2025 12:15 am
JoelTrucordia
(@joeltrucordia)
Member
Topic starter answered:
RE:

 

Well I forced it to print without the calibration and it printed just fine. I’m at a loss

This post was modified 1 week ago by JoelTrucordia
Posted : 18/07/2025 1:52 am
Share: