PrusaLink still buggy for people?
 
Notifications
Clear all

PrusaLink still buggy for people?  

  RSS
Geri
 Geri
(@geri-2)
Active Member
PrusaLink still buggy for people?

I attempted to use PrusaLink last year for a few days, and promptly stopped after errors and prints just randomly stopping due to corrupted files.

A year later I go back to it, and it worked for a couple prints, until it sent over a corrupted file where my MK4 just stopped with an error message related to the USB.

After I removed the USB and tried to plug it into my PC.. it was bricked.. It literally killed my USB and it wouldn't even get recognized anymore afterwards. Kind of a crazy thing to happen when a $1000 machine is involved..

Anyone else have issues with Prusalink like that? I haven't purchased any amazing USBs so not sure if a better one would be less susceptible, but it sure seems like the Gcode transfer via Prusalink is very unreliable on wifi and often corrupts..

Posted : 17/09/2024 8:20 pm
3D-Print Brehm
(@3d-print-brehm)
Trusted Member
RE: PrusaLink still buggy for people?

Hello Geri,It's a shame that it didn't work for you with PrusaConnect. I can only say that this is an isolated case.We worked through the problem in another entry and that was also a good solution, because I haven't had this error since then.I think PrusaConnect is great.Best wishes, Sven

inkompatibel-usb-stick-am-prusa-mk4

https://forum.prusa3d.com/forum/hilfe-zur-hardware-firmware-und-software-3/inkompatibel-usb-stick-am-prusa-mk4/#post-721016

Posted : 18/09/2024 4:38 am
Share: