Notifications
Clear all
Noel
Group: Registered
Joined: 2020/11/23
Active Member
1
About Me
I am a retired electronics engineer. In 2014 I built a Lulzbot Kittaz and did some printing with both PLA and ABS. The KITTAZ was shelved for a few years and I decided I should leave it there and assemble a new MK3S. I have no interest in printing with PLA, I purchased a few rolls of Prusament PETG aiming for consistent good results.
Social Networks
Member Activity
0
Question Comments
0
Liked
1
Received Likes
1/10
Rating
0
Blog Posts
0
Blog Comments