Notifications
Clear all
Prusa XL - Quick Start GCode - Without nozzle cleaning
Hello.
After the firmware (6.4.0.) update, not only I but also many other (Prusa XL) users had problems with nozzle cleaning.
I have also reported this behaviour on GitHub. Then i decided to try changing the start logic myself.
The result can be found here:
Printables - Prusa XL - Quick Start G-Code - Without Nozzle Cleaning
After printing five small models with this modified GCode today, I wanted to put it online for you to try.
It is important to note that the nozzle must be cleaned at the bottom before each print job. It must be free of any filament residue.
Bye Jan
This topic was modified 8 hours ago by jan.d.slay
Posted : 12/12/2025 5:28 pm