Prusa3D Forum - Recent Topics

Prusa Slicer Pyhsical Printer and UN/PW

RCarnaroli — Thu, 07 May 2026 01:12:36 +0000

So I just got my C1L and I noticed every time I opened P Slicer and went to view the printer, I had to re-enter the UN/PW in whatever browser it's spawning. Iplayed around a little and looked in the forums. I didn't find exactly my issue. So in case anyone else comes across this, I fixed it by putting the UN and PW in the URL in Slicer. So maker:longrandompassword@the_ip_on_your_network. I left the username and password in the config too. But I think it's not using them.

6.4.1 Firmware quirk

JH — Wed, 06 May 2026 22:23:00 +0000

I've noticed that if I stop a print, the head moves away and crashes into the left side. Upon starting a new print after the stop event the head attempts to home being already against the side and stresses the motor/belts. I think it would be nice if a print is stopped/ended the head would park and stop in a place that would cause mechanical stresses if a new print is started with reset or powering off the machine first

Metallic Screech/Rattle with travel moves

Jason3D — Wed, 06 May 2026 19:35:14 +0000

So my Core One L is making a metallic screech/rattle noise, it only appears when doing travel moves. I've redone belt Tension, input shapers and phase stepping, but no luck unfortunately. Does anyone have ideas on what to try?

Would anyone be interested in streamdeck plugin that connects to prusalink?

Enspiron — Wed, 06 May 2026 19:13:43 +0000

Hello there!

I created a stream deck plugin that uses PrusaLink's api to connect to the printer using just the printer's authentication like local ip, user, and password.

It lets you monitor your print progress, hot end + heatbed temps and more.

I borrowed some assets the git but other than that I have done the rest.

Would you be fine with a price of $5 for the development of integrating the API into the stream deck plugin and making it look nice? Let me know so I can gauge the response!