Extruder Error(s) after 6.2.0 - General discussion, announcements and releases https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-general-discussion-announcements-and-releases/extruder-errors-after-6-2-0/ Prusa3D Forum Discussion Board en-US Wed, 17 Jun 2026 19:31:56 +0000 wpForo 60 RE: https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-general-discussion-announcements-and-releases/extruder-errors-after-6-2-0/#post-737108 Tue, 18 Feb 2025 22:48:45 +0000 I am getting this error on TH5. I have removed the cover to see if it will stop the error.

]]> General discussion, announcements and releases Macmagoo https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-general-discussion-announcements-and-releases/extruder-errors-after-6-2-0/#post-737108 RE: Extruder Error(s) after 6.2.0 https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-general-discussion-announcements-and-releases/extruder-errors-after-6-2-0/#post-735067 Mon, 03 Feb 2025 16:49:09 +0000 Check out https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/4400

 

]]> General discussion, announcements and releases FoxRun3D https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-general-discussion-announcements-and-releases/extruder-errors-after-6-2-0/#post-735067 RE: Extruder Error(s) after 6.2.0 https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-general-discussion-announcements-and-releases/extruder-errors-after-6-2-0/#post-734817 Sun, 02 Feb 2025 06:19:53 +0000 Worse yet is after this all red screen error occurs, the printer just sits there and beeps, the json/printer/state is not updated to PAUSED/STOPPED/ERROR/ATTENTION so I am never notified :(

]]> General discussion, announcements and releases JPMakesStuff https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-general-discussion-announcements-and-releases/extruder-errors-after-6-2-0/#post-734817 Extruder Error(s) after 6.2.0 https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-general-discussion-announcements-and-releases/extruder-errors-after-6-2-0/#post-734816 Sun, 02 Feb 2025 06:13:17 +0000 After upgrading to 6.2.0 I have experienced two failed prints, both with "Extruder Error - motor is not spinning on tool X" (on both tool 1 and tool 2 thus far)

But when I go to unload/load filament, works fine, and print starts fine

What has gone wrong?

]]> General discussion, announcements and releases JPMakesStuff https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-general-discussion-announcements-and-releases/extruder-errors-after-6-2-0/#post-734816