Notifications
Clear all
Custom start GCode for the XL
I have created a GitHub repo that holds my tweaked XL start Gcode. You have likely seen some of my posts about it here, but I wanted to put it out there for feedback, to let others use it, and to offer pull requests/suggestions.
There are a few versions, with one including a 5-minute full-bed extended pre-heat to 100 C for forcing thermal expansion before probing the bed.
https://github.com/DoubleStrike/PrusaXL_TweakedGCode
Brand new to 3D printing and my 5-tool XL is my first 3D Printer!Check out my Multi-Tool fork of PrusaSlicer to mix and match nozzle sizes.
Posted : 12/11/2025 8:34 pm