Notifications
Clear all
failing filament sensor test
Filament sensor for extruder 2, on the side of the XL is failing. The other 4 have passed.
I've replaced the filament sensor. I've checked both ends of the cable. What do I try next?
It reads filament present when there is none in the sensor.
This topic was modified 11 months ago by Paul42
Posted : 01/03/2024 3:30 pm
RE:
I had exactly the same problem (side sensor 2). A hard reset, followed by reflashing the firmware and recalibrating the printer fixed it (as advised by Prusa Support)
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Posted : 01/03/2024 4:37 pm