Crash detection on Head 1
First of all, the printer has been used 6 month without any problem.
Suddenly I get bed leveling problems left back. After a few sessions with Prusa support where they had me redo the docking calibration.
The bed leveling problem seemed to be due to the belt had loosen a bit
I have calibrated and run the docking calibration on head 1 again but every change (not the first pickup) now gets crash detection error and if I just press the knob it doe the homing again and continues without problem.
What could be the issue?
New docking calibration again?
Best Answer by Tellblom:
Seems like the docking calibration on all heads done three times in a row got it back to the working phase again
RE: Crash detection on Head 1
Seems like the docking calibration on all heads done three times in a row got it back to the working phase again