Notifications
Clear all
Error # 10109 - too much resin error, when the resin is well below 100%
Hi folks,
Pretty much brand new to SL printing. Fairly experienced with FDM.
I've got a brand new SL1S running firmware V 1.7.2, and I've gotten a few prints off quite nicely. I just tried to start a new one, and it's giving me "error 10109"
I checked the resin level, and it was slightly below 100%, so I removed a few ounces from it - down below the 70% line, but was still getting the error. I emptied and cleaned the tank, and re-calibrated the build platform, filled the resin back up to below 70%, and it's still throwing the error.
I've googled around a little, and don't see much on point. Is there something else that could cause this error? A broken or dirty sensor maybe?
thx!
AJ
Posted : 06/05/2024 1:07 am