Vaciar todo

Step 1 🙁  

New Member
Step 1 🙁

Gents - kit arrived today, and we are ready to go.  Unfortunately it looks like we've run into a bit of a problem.  On the Part 2, Step 6, it looks like the holes in the base were not drilled and tapped deep enough.  I'm assuming they are supposed to be "tight" when the M4x8's are tightened?

Respondido : 13/08/2019 12:51 am
Trusted Member
RE: Step 1 🙁

Hi John,

Best to contact Prusa support for this. Maybe the screws are not the good ones?

Respondido : 16/08/2019 5:55 pm
Active Member
RE: Step 1 🙁

Hi John,

perhaps need some washers?

BTW you got the kit!?! did they start sending? I did not see any news on the shipping table... Are you a day one order or a tester?


Respondido : 16/08/2019 8:14 pm