Bed Heating failure
I had a bed thermal runaway I shut down the printer, and turned it back on, cleared for a restart. When I restarted, the bed would not heat. I looked for wires to the bed heater, but for whatever reason could not find any (there must be wires to the bed heater somewhere...).
Is this a motherboard issue, or a bed issue? How do I proceed? And where are the wires connected to the bed for heating?
RE: Bed Heating failure
what printer?
We will do what we have always done. We will find hope in the impossible.
RE: Bed Heating failure
Ah, sorry. I thought I had selected the MK3S+ 3.5 forum. That is what I have - the 10th anniversary version of the MK3.
RE: Bed Heating failure
Heatbed Power connection Assembly step 10 at this address
https://help.prusa3d.com/guide/6-heatbed-upgrade_617239#621123
Controller / heatbed connector assembly step 24
https://help.prusa3d.com/guide/6-heatbed-upgrade_617239#621771
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK