Notifications
Clear all
Spooljoin doesn't recognize when Filament is out.
I have a core one with mmu3 and tried spooljoin for the first time. When the filament ran out, I watched the 2 filament sensors indicate it knew there was no filament. However , It continued to print in mid air. am I doing something wrong. The sensors seem to work fine.
Posted : 09/09/2025 9:28 pm
RE: Spooljoin doesn't recognize when Filament is out.
Have you found a fix for this yet? I am running into the same issue and haven't found much on Google in regards to this.
Posted : 24/10/2025 1:16 pm