Notifications
Clear all
Extruder crashing on wipe tower
I've just updated to the "new" firmware, and on my first print I had the layers shift. This happened three times. The culprit is the wipe tower. For some reason, large blobs of filament are deposited into the wipe tower on filament change. Eventually, the buildup will cause the extruder to drag and the motors will skip steps.
This is happening on my CoreOne+. I've got the Coreboxx on top with active smart rewinders by @mire.
Attached is a pic of one of the wipe towers. I've tried adjusting settings on the wipe tower, and it makes no difference. Eventually the extruder crashes and ruins the print. I've tried this print three times now.
Publié : 16/04/2026 7:46 pm