Notifications
Clear all
Loading problems......
After using my MMU3 fine for weeks, it has suddenly stopped loading and feeding filament.
Filament was already preloaded too!
I have remove date filaments, and it seems the pulls are just biting into the filament rather then push it forward to the pinda sensor.
I have tried adjusting the screws but it makes no difference.
Ive checked the PTFE tube routes etc, and all are clear.
Filament has a nice tip too.
Any ideas why the pulls are just eating into the filament rather then push it through to the sensor?
Posted : 02/02/2025 12:42 pm