Notifications
Clear all
Wipe tower and detachable supports - slicing issue
Hi,
I just installed the MMU2S and could get it to run consistently with PLA and PETG.
However, something weird happens everytime I try to slice an object with supports enabled (I am talking about detachable, 0.2 gap interface).
If supports are enabled, the wipetower becomes HUGE and out of control. See attached picture for comparison of the same object sliced with and without support enabled.
I tried playing a bit with the settings but could not figure it out. Maybe is something very simple that i am missing, or maybe a bug?
Posted : 29/04/2020 7:43 am