Notifications
Clear all

Wipe tower  

  RSS
Woodrow Collins
(@woodrow-collins)
Active Member
Wipe tower

So is there any way to either randomize the location that the unload filament lines happen or have the print head continue out past the edge of the wipe tower before moving the head away to perform a tool change?  I am having an issue in which the a blob of filament seems to occur with a pillar at the location the unload lines end and is only deposited after the unload / tool head change.

Posted : 30/11/2020 2:50 am
Calire
(@calire)
Honorable Member
RE: Wipe tower

Hello.

Just a   "truc-muche" : the picture is blurred.  Please  an another to see better ;   lovmidou.

Posted : 30/11/2020 6:49 am
Woodrow Collins
(@woodrow-collins)
Active Member
Topic starter answered:
RE: Wipe tower

@calire

I'll see if I can snap another picture when I do another multi color print.  Though the more research I do the more I may opt to go with a purge bucket over a purge tower.

Posted : 30/11/2020 1:26 pm
Share: