Migrating the MMU2S?
Greetings!
I'm currently playing with the idea of building a bigger 3D Printer with manual tool swapping capability to entirely replace my i3 MK3S but not the accompanying MMU2S and as such I'd like to migrate the MMU2S over to the new Printer which must be based on SKR 1.4 Boards hooked up to an RB-Pi.
Question thus:
Can a MMU2S be run from either the SKR 1.4 Board or the accompanying RB-Pi and what would that look like in detail?
RE: Migrating the MMU2S?
Greetings!
I'm currently playing with the idea of building a bigger 3D Printer with manual tool swapping capability to entirely replace my i3 MK3S but not the accompanying MMU2S and as such I'd like to migrate the MMU2S over to the new Printer which must be based on SKR 1.4 Boards hooked up to an RB-Pi.
Question thus:
Can a MMU2S be run from either the SKR 1.4 Board or the accompanying RB-Pi and what would that look like in detail?
I don't know if anyone here on the forum has done this before, but here is a video about it:
I haven't tested it myself, so I can't comment further.
good luck!
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.