Would love to see some review videos
Maybe too early but I would love to see some review videos. Would like to see if the waste block is just as big for similar prints as the last one.
I am holding off buying one for now. Maybe around Christmas if it gets some good reviews.
Re: Would love to see some review videos
Why would the waste tower be smaller? The hotend needs to be purged, this is unchanged. BTW did you notice how much a spool of BVOH is?
I'd perfer a dual nozzle/hotend solution, but I guess I have to get an UM3 for this. Ordered the MMU2 right now...
- Martin
- Martin
Re: Would love to see some review videos
Why would the waste tower be smaller? The hotend needs to be purged, this is unchanged. BTW did you notice how much a spool of BVOH is?
I'd perfer a dual nozzle/hotend solution, but I guess I have to get an UM3 for this. Ordered the MMU2 right now...
- Martin
Jo put out that the filament waste would be used for infill. This is a good concept and may contribute to reduced waste.
Re: Would love to see some review videos
Why would the waste tower be smaller? The hotend needs to be purged, this is unchanged. BTW did you notice how much a spool of BVOH is?
I'd perfer a dual nozzle/hotend solution, but I guess I have to get an UM3 for this. Ordered the MMU2 right now...
- Martin
or... just buy a e3d dual hot end? course no support for another heater on that board. at least ramps did. a 4k um3 just for that is quite overkill.