Re: last commit for mmu2_v2 firmware - Jul24??
From button.cpp:
//! @brief Show setup menu
//!
//! Items are selected by left and right buttons, activated by middle button.
//!
//! LED indication of states
//!
//! RG | RG | RG | RG | RG | meaning
//! -- | -- | -- | -- | -- | ------------------------
//! 11 | 00 | 00 | 00 | 01 | initial state, no action
//! 11 | 00 | 00 | 01 | 00 | setup bowden length
//! 11 | 00 | 01 | 00 | 00 | erase EEPROM if unlocked
//! 11 | 01 | 00 | 00 | 00 | unlock EEPROM erase
//! 11 | 00 | 00 | 00 | 00 | exit setup menu
//!
//! @n R - Red LED
//! @n G - Green LED
//! @n 1 - active
//! @n 0 - inactive
Seems to exit serive menu after all pulleys calibrated. Move selector to position 1, press on hold middle button??? I will confirm later...
Prusa MK3 > MK4s
Prusa MK2.5 kit > MK3 > MK3s > MK4s
Prusa SL1 3D printer + Curing and Washing Machine (day1 order)
Taz6 - taken apart for space
CR10s4 - upgrading
Delta 3ku - dont use
Re: last commit for mmu2_v2 firmware - Jul24??
Seems to exit serive menu after all pulleys calibrated. Move selector to position 1, press on hold middle button??? I will confirm later...
To exit the menu, you move the selector to the very right (past F5) and then press the middle button.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Re: last commit for mmu2_v2 firmware - Jul24??
Seems to exit serive menu after all pulleys calibrated. Move selector to position 1, press on hold middle button??? I will confirm later...
To exit the menu, you move the selector to the very right (past F5) and then press the middle button.
Peter
Thank you, as always good Sir.
Prusa MK3 > MK4s
Prusa MK2.5 kit > MK3 > MK3s > MK4s
Prusa SL1 3D printer + Curing and Washing Machine (day1 order)
Taz6 - taken apart for space
CR10s4 - upgrading
Delta 3ku - dont use