MMU2S initial install stepper buzzing after limit routine
 
Notifications
Clear all

MMU2S initial install stepper buzzing after limit routine  

  RSS
DougM
(@dougm)
New Member
MMU2S initial install stepper buzzing after limit routine
This is a fresh install of an MMU2S.  Mechanically everything seemed to go together fine, but when I try to load filament the stepper motor that rotates the loader seems to find its limits fine, but then it just starts buzzing, the orange light blinks and nothing works.  Here is a link to a video.
 
 
I flashed both the MK3 and the MMU with firmware downloaded yesterday.
 
Can you tell me what to look for to fix it?

Publié : 09/02/2020 6:18 pm
Partager :