Notifications
Clear all
Idler turning the wrong direction / Power problems?
I just finished assembling my mmu2s, but when I try to load a filament, the idler seems to turn into the wrong direction and after a short time all led flash orange (red + green?)
I read that this could be a power problem, but I checked the power cable and the motor cables and they all seem to be screwed tight / sit well. What would be the next steps?
Video (this happens both with loading from the mmu and from the printer menu):
Posted : 06/07/2019 11:18 am
Topic starter
answered:
RE: Idler turning the wrong direction / Power problems?
Turns out those where the "red" LEDs and the finda probe was a little bit too low, reporting a loaded filament...
Posted : 06/07/2019 5:29 pm