Z axis calibration issue with E3D-V6 volcano
I purchased the E3D-V6 volcano which is longer than the original, this makes the calibration of the Z-axis fail, I am guessing because it does not have the full travel. Is there a way to change the expected travel on the Z-axis?
Re: Z axis calibration issue with E3D-V6 volcano
you can update the firmware, or print different parts to enable the travel within the existing frame
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Re: Z axis calibration issue with E3D-V6 volcano
When I connect to the board in Marlin Arduino (vers 1.8.7) on my Prusa I3 Mk3 (firmware version 3.4.0-1327) for board it shows 'Arduino Mini' with the processor ATmega328P, I thought it was supposed to show Mini-Rambo, maybe this is the same? If not, is there a link for Marlin Arduino for the Prusa, I found some early ones that did not look right.