XYZ and PINDA errors?
I'm not sure what's going on - I was happily printing yesterday night, but when I woke up today, suddenly the mesh bed levelling failed at the second probe point, saying something along the lines of "probe wiring broken". I went ahead and tried a xyz calibration, and it returned an error, so I updated to new firmware and tried again, then updated the firmware again and tried again, and it kept returning errors. There's a link to the error below - it looks like it just doesn't even try to probe at the second and third points and then returns an error.
I've previously had some errors with the PINDA probe having offset results, but it's always worked.
Presumed error can be seen around 40 seconds at the second and third calibration points
Re: XYZ and PINDA errors?
Seems the problem was fixed by changing the PINDA probe