Notifications
Clear all
Testing a full bed 1 layer print after calibration
I upgraded to the latest version and ended up doing a full calibration (X/Y/Z) since my prints are not sticking. After running the calibration and setting my Z offset, I printed a 1 layer full bed after running the v2calibration gcode. This is only one layer but there are several lines in the print and they're pretty obvious and not sure if this will affect when I start doing long prints.
pics of the 1 layer print
https://imgur.com/a/km9wl
Any ideas?
thanks!
Posted : 09/09/2016 9:15 am