Notifications
Clear all

long beep when heating bed and nozzle  

  RSS
mgt
 mgt
(@mgt)
New Member
long beep when heating bed and nozzle

Hi

My printer works very well, but from time to time, there is a long beep from the power when bed and nozzle heating starts.
It's appear before 180°C and when it's come, I just power off / on and problem seem solved..

Any clue ?

Posted : 09/07/2016 5:10 am
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: long beep when heating bed and nozzle

Hi Mahmoud

Which printer and firmware are you running?

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Posted : 09/07/2016 6:49 am
mgt
 mgt
(@mgt)
New Member
Topic starter answered:
Re: long beep when heating bed and nozzle

Original Prusa i3 MK2 kit - color : Black and orange
Firmware 3.0.3

Posted : 09/07/2016 2:42 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: long beep when heating bed and nozzle

Mahmoud

I think the best thing to do is to contact support - use the "live chat" on the shop pages. Give them a link to this thread.

If you get it resolved, can you post the solution here.

Thanks

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Posted : 09/07/2016 10:13 pm
mgt
 mgt
(@mgt)
New Member
Topic starter answered:
Re: long beep when heating bed and nozzle

After few days the problem disapear completly ...

Posted : 25/07/2016 6:52 pm
Share: