Notifications
Clear all
How do I get this of my print bed?
I printed with PETG for the first time (bad result, but that's off topic here). The object wasn't really stuck on the build plate. It came of with very little resistance, however it left this trace which does not disappear with glass cleaner.
Any suggestions?
Posted : 03/11/2017 10:44 am
Re: How do I get this of my print bed?
Try to use Aceton or 99% IPA.
I scrub down my PEI with soap and water using the green side of a (yes what is the name :-)) wash sponge once in a while.
---
Gert
Posted : 03/11/2017 11:45 am
Re: How do I get this of my print bed?
That is just where the PEI has lifted very slightly. It will disappear after a few heat cycles.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Posted : 03/11/2017 12:00 pm