Front Fan Not Spinning
I have proceeded through the calibration to the point where I am running the V2Calibration.gcode to do the level calibration. My question is that the front fan does not operate, however, the front fan operates correctly during the selftest. I only let the print run for a very short time before stopping it. Should the front fan be operating at all times during a print?
Re: Front Fan Not Spinning
The fan doesnt normally run on the first layer
Try a pla demo model and the fan should run from layer 2 on.
On PETG. The fan may not start until say layer 4
Abs doesnt usually use a fan
Regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK