Bottom layer problems
Hey all,
I was wondering if someone could help diagnose some issues I've been having with my bottom layer. I'm printing with an MK3 built from a kit in PLA, and I seeing bottom layers like this after removing from the bed. I assume the bottom layer should look completely smooth, but large portions of it still show the separate strands of filament.
Could anyone point me in the direction of what might be the likely problem? Thanks!
Re: Bottom layer problems
this first layer too low
Re: Bottom layer problems
You need to fix your Live Z setting, it is too low. See Life Adjust Z My Way thread.
Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…