Notifications
Clear all

Top Layer Issues  

  RSS
matt.g6
(@matt-g6)
New Member
Top Layer Issues

I keep getting this stringyness on the top layers of my prints. I think it's an extrusion issue, but I'm not sure since I'm very new to 3D printing. Anyone have tips for solving this issue?

Thanks

Posted : 22/07/2017 7:49 pm
AJS
 AJS
(@ajs)
Noble Member
Re: Top Layer Issues

Does it do this on a pre-sliced Goode, or only on the ones you have sliced?

Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…

Posted : 24/07/2017 5:09 am
Share: