The Need for Speed
I have mostly been doing PLA prints and typically have really good quality prints - just using the standard Prusa .20 Normal settings in Slic3r.
Obviously I would love to decrease the total print time if possible. The prints I am getting look really good so I am thinking that with the quality of this printer it could probably still put out some good quality items even with a nice little increase in speed.
So my question is, what recommendations are there for increasing the speeds and /or the hot end -I'm assuming there is a need for a certain amount temp increase due to the less time the filament will have in the hot end. Initially just talking about PLA, nothing exotic.
I guess this could also serve as sort of a survey too? As in, what is the fastest you have printed with the MK2 and still had successful, good looking prints?
Thanks!
Re: The Need for Speed
Quick answer: http://shop.prusa3d.com/forum/search.php?keywords=maximum+speed
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…