Notifications
Clear all

Slicer settings for bundled prints  

  RSS
nick.c3
(@nick-c3)
Active Member
Slicer settings for bundled prints

Sorry if this has been asked, but I'm curious what slicing software, and most importantly, settings were used for the G-code of the bundled 3D models that come on the SD card. Specifically, I have printed the Prusa logo, Marvin and Treefrog. The treefrog is extremely impressive, and I'd like to know how it was sliced as a benchmark.

Posted : 24/01/2017 3:21 am
David T.
(@david-t)
Noble Member
Re: Slicer settings for bundled prints

PR uses Slic3r, AFAIK. The settings should be present in the gcode. Look at gcode in text editor. All settings should be at end of the file.

Posted : 24/01/2017 9:22 am
Share: