ApolloX
I tried ApolloX because it doesnt warp like ABS. A very nice material, easy to print and very good results.
There is only one problem: It sticks too well to the heatbed. It is very hard to remove the modells. Does anyone have a hint how to decrease the stick on the headbed or how to remove the modell without damaging the PEI?
Thomas
Re: ApolloX
Very light dusting with talcum powder.
Or you could use glue stick.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Re: ApolloX
I tried Talkum, works great! Thank you Peter!
Thomas
Re: ApolloX
The best solution for ApolloX is cleaning the bed with blue window cleaner. It decreases the massive stick on the bed.
My settings for the filament:
Print temperature: 240°C
Bed: 80°C
Cooling: No cooling
Works perfekt, very strong filament with 40 percent infill.
Thomas